Shindaiwa EB8520RT Instrukcja Operatora Pobierz pdf (Strona 16)

Before you start

Before yo u start

Assembly

Install blower pipes

Place the blower upright on the ground or on a sturdy work sur-

face.

1. Fix anti-static wire eyelet to right hand engine cover screw

(A).

2. Turn elbow out to a right angle and slip anti-static wire

through the 102 mm clamp and flexible pipe.

3. Install throttle cable holder just forward of the 102 mm clamp,

pinching loops together to fit over end of flexible pipe.

4. Slip the flexible pipe over the end of elbow, and secure with

the 102 mm clamp.

5. Slide the throttle assembly over the swivel pipe. Do not tight-

en clamp at this time.

6. Insert the anti-static wire through the swivel pipe, then install

and tighten the 89 mm clamp over the rotating band on the

swivel pipe.

7. Fold the end of the anti-static wire back over the connection

of the swivel pipe.

8. Grasp the straight pipe, and push the straight pipe over the

swivel pipe locking pins securing the anti-static wire.

9. Lock the straight pipe to the swivel pipe by rotating the

straight pipe noting the alignment marks.

10. Grasp the nozzle and lock the nozzle to the straight pipe as

in steps 8 and 9.

WARNING



Read the operator's manual carefully to ensure that you assemble the product correctly.



Never perform maintenance or assembly procedures with engine running.

 Using a product that has been incorrectly assembled could lead to an accident or serious injury.

1. Anti-static wire

3. Clamp

5. Throttle cable holder

7. Swivel pipe

2. Elbow

4. Flexible pipe

6. Throttle assembly

NOTE

This unit is equipped with a static discharge reduction wire.

This wire helps direct static buildup into the air stream reducing

the felt amount to the operator.

NOTE

Check to make sure that elbow swivels freely. If any binding is

present, loosen 102 mm clamp and pull wire towards engine to

get more slack and recheck for free movement.

1. Straight pipe

3. Locking pin

2. Swivel pipe

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 135 136

Komentarze do niniejszej Instrukcji

Brak uwag

Shindaiwa EB8520RT Instrukcja Operatora Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Silnik Shindaiwa EB8520RT